  |
|
For a pdf file of this product, please click
here.
| PulsePoint |
Retrofit gas meter pulse
device
 |
| RIOTronics,
a manufacturer of intelligent metering products, has developed a
new meter sensor product called PulsePoint. |
 |
FEATURES AND BENEFITS:
u Fast
Field retrofit
u Avoids
epoxy
u No
index change out
u Index
cover is pulled out only 1/32”
u High
Resolution: 2 pulse/revolution of test dial
u Dual
outputs option
u Wire
tamper detection option
u Form
A long life switch
u Compatible
with most AMR, loggers, EMS and
gateways
AVAILABLE CURRENTLY FOR:
American Meter:
Domestic meters, circular read and
direct read indices
For sizes 175 and 250CFH Models
Click for more product photos
Invensys/Equimeter:
Domestic
meters, circular read R-275 index
Click for more product photos
Actaris/Schlumberger/Sprague:
Domestic meters, direct read and
circular read indices
For sizes 240, 250, and 400 CFH Models
Click for more procuct photos
SPECIFICATIONS:
Form A digital switch, 2nd switch optional
2 contacts per revolution of the test dial
Duty Cycle: 20%on, 80%off
Pulse rate: Determined by meter, typical 3 seconds min/pulse
Optional: Transistor type FET output, with customized pulse length
Optional: Wire tamper detection circuits
Max. switch voltage: 180 V DC
Max. sw. rating: 8 W
100 ohm series resistance added to circuit
Breakdown voltage: 220 V DC
Operate time w/ bounce: 0.5ms
Operational Temperature: -40C - 130C
INSTALLATION:
u Remove index box and index
u Snap
magnet carrier clip onto index drive shaft
at rear of index
u Mount
switch bracket between the meter body
and the index meter, aligning bracket holes with
index mount holes
u Fasten the index screws to secure the index and
the switch bracket, use custom screws
if provided.
u Drill 7/32” hole for grommet and exit the wire through
the grommet
u Secure the index box, and connect the wires to the AMR
or logger. There is no polarity for the wires.
 
|
